Bluefish444 Create3D Bedienungsanleitung PDF herunterladen (Seite 16)

you can set this parameter to the size of this space. Nemo will try and change the

parameters of the font to squeeze it until it meets this requirement.

If maxWidth>0, by reducing first the kerning, then if necessary charWidth and if that is

still not enough, the charHeight parameter Nemo attempts to compress the text to fit the

size set by maxWidth. You can also set the minimum value of these properties (kerning,

width and height) below which it should not get decreased in the process of compressing

the text to the size set by maxWidth.

• justifyX: justify horizontally. It is possible to justify to the left, to the center and to the right.

• justifyY: justify vertically. Possible values are bottom, middle and top.

• wordwrap: splits the text into lines but keep words intact.

• typeWriter: this is an old CG effect in which characters appear one after the other. If the

value is 1, all characters are visible, if it is 0, none. If you animate this parameter from 0

to 1, you achieve a typewriter effect with definable speed.

• tWfade: used for the typewriter effect, it sets the amount of fade between characters that

are already visible and those that are not.

• character animation: switching on and off the animation of individual characters in a text.

• charOffsetX, charOffsetY, charOffsetZ: The distance between the characters of the text

increases with the value set for these parameters (along axis x, y, z). By animating this

value in such a way that the final value is 0, characters 'fly in' one by one.

• charOffsetT: Adds a time offset to values set for the previous three properties. The

maximum value is 20 and is measured in frames (of which in SD PAL there are 25 in a

second).

• background: you can place a rectangular strap behind the text. Its size is always defined

by the size of the text in the x,y direction. The material for this strap can be chosen from a

dropdown list of available Materials.

• offsetL, offsetR, offsetB, offsetT: if you wish to create a strap bigger than the text itself,

this can be done in all directions (L=left, R=right, B=bottom, T=top).

ClipBox parameters:

For each Object this box defines the boundaries of its existence in 3D space. Parts of the Object

that lie outside of this box are not visible. The box itself is created as the intersection of six

planes. These are called the clipping planes. The name of the planes are as follows:

L=left

R=right

B=bottom

T=top

N=near

F=far

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 124 125

Keine Kommentare

Bluefish444 Create3D Bedienungsanleitung Seite 16